Subaru Crosstrek Service Manual: Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and Harness
REMOVAL
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Disconnect the ground cable from battery.
2. Remove the clip (A) from the air intake boot.
3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).
4. Loosen the clamp (C) which connects the air intake boot and throttle body.
5. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.
6. Disconnect the connector back-up light switch & neutral position switch.
(A) | Neutral position switch connector (brown) |
(B) | Back-up light switch connector (gray) |
7. Remove the harness connector from bracket.
8. Lift up the vehicle.
9. Remove the harness from each clip.
10. Remove the back-up light switch & neutral position switch with the harness.
(A) | Neutral position switch |
(B) | Back-up light switch |
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSPECTION1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resi ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSTALLATION1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Install the back-up light switch & neutral position switch with the ha ...
Other materials:
Ignition control system
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostics for Engine Starting FailureIGNITION CONTROL SYSTEMCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode">, and Inspection Mode Inspection Mode">.Wiring diagram:Engine electrical system Engine Elec ...
Replacement
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Oil SealREPLACEMENT1. Disconnect the ground cable from battery.2. Lift up the vehicle.3. Clean the transmission exterior.4. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.CAUTION:• Immediately after ...
Installation
COOLING(H4DO) > Water PumpINSTALLATION1. WATER PUMP PULLEY1. Using the ST, install the water pump pulley.ST1 18355AA000PULLEY WRENCHST2 18334AA030PULLEY WRENCH PIN SETTightening torque:14 N·m (1.4 kgf-m, 10.3 ft-lb)2. Install the under cover. Front Under Cover > INSTALLATION" ...
