Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and Harness
INSTALLATION
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Install the back-up light switch & neutral position switch with the harness.
NOTE:
Use a new gasket.
Tightening torque:
32.3 N·m (3.3 kgf-m, 23.8 ft-lb)
(A) | Neutral position switch |
(B) | Back-up light switch |
2. Secure the harness on each clip.
3. Lower the vehicle.
4. Connect the connectors for back-up light switch and neutral position switch, and secure the connector to the bracket.
5. Install the air intake boot. Air Intake Boot > INSTALLATION">
6. Connect the battery ground terminal.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessREMOVAL1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air in ...
Other materials:
Caution
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General DescriptionCAUTION1. BSD/RCTA(1) In some cases, BSD/RCTA may not work correctly under the following conditions.• In bad weather such as heavy rain, fog, snow, sand storm, etc.• When ice, snow, dirt, etc. cover the r ...
Installation
FRONT SUSPENSION > Front CrossmemberINSTALLATION1. Check the crossmember for damage or cracks, and correct or replace if defective.2. Install the universal joint assembly - steering. Universal Joint > INSTALLATION">3. Install each part in the reverse order of removal.CAUTION:• U ...
Assembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyASSEMBLY1. Install the bracket to the leak check valve assembly.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)2. Install the drain tube to the leak check valve assembly.CAUTION:• Check that there is n ...
