Subaru Crosstrek Service Manual: Replacement

1. Disconnect the ground cable from battery.

2. Lift up the vehicle.

3. Clean the transmission exterior.

4. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.

CAUTION:

• Immediately after the vehicle has been running or after idling for a long time, the gear oil will be hot. Be careful not to receive burns.

• Be careful not to spill the gear oil on the exhaust pipe, to prevent emission of smoke or causing a fire. If gear oil is spilled, wipe it off completely.

5. Attach the drain plug using TORX® bit T70.

NOTE:

Use a new gasket.

Tightening torque:

44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, silver)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (copper gasket, brown)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (metal gasket, black)

6. Remove the rear exhaust pipe. Rear Exhaust Pipe > REMOVAL">

7. Remove the center exhaust cover.

8. Remove the propeller shaft. Propeller Shaft > REMOVAL">

9. Using the ST, remove the oil seal.

10. Using the ST, install the oil seal.

NOTE:

• When grease is not applied to the oil seal lips, apply the transmission gear oil to the oil seal lips.

• Use a new oil seal.

11. Install the propeller shaft. Propeller Shaft > INSTALLATION">

12. Install the center exhaust cover.

Tightening torque:

18 N·m (1.8 kgf-m, 13.3 ft-lb)

13. Install the rear exhaust pipe. Rear Exhaust Pipe > INSTALLATION">

14. Lower the vehicle.

15. Pour in transmission gear oil and check the oil level. Transmission Gear Oil">

16. Connect the battery ground terminal.

Inspection

Reverse check sleeve

Other materials:

Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyDISASSEMBLY1. DIFFERENTIAL CASE ASSEMBLY1. Remove the twelve bolts and remove hypoid driven gear.(A)Hypoid driven gear2. Drive out the straight pin from differential assembly toward hypoid driven gear side.ST 899904100STRAI ...

Safety precautions
WARNING Always use the utmost care in driving - overconfidence because you are driving a vehicle with the Vehicle Dynamics Control system could easily lead to a serious accident. CAUTION Even if your vehicle is equipped with Vehicle Dynamics Control system, winter tires should be used when ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Speed SensorINSPECTION1. Set the ST between the TCM and bulkhead harness.ST 18460AA040CHECK BOARD2. Set the probe of oscilloscope to the check board connector.Connector & terminalNo. 13 (+) — No. 42 (−):(A)+ probe(B)− prob ...