Subaru Crosstrek Service Manual: Inspection

1. BACK-UP LIGHT SWITCH

1. Turn the ignition switch to OFF.

2. Disconnect the back light switch connector.

3. Measure the resistance between the back-up light switch terminals.

4. Replace faulty parts.

1. Turn the ignition switch to OFF.

2. Disconnect the connector of neutral position switch.

3. Measure the resistance between neutral position switch terminals.

4. Replace faulty parts.

Switches and harness

Removal

Other materials:

Dtc p2196 a/f /o2 sensor signal biased/stuck rich bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2196 A/F /O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 1DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Cle ...

Fastening the seatbelt
Front seatbelts 1. Adjust the seating position in the Subaru Ascent according to the following guidelines. Driver's seat: Set the seatback to an upright position and move the seat as far back from the steering wheel as possible while maintaining full control of the vehicle. Front passenge ...

Hill start assist warning light/Hill start assist OFF indicator light
Hill start assist warning light While the engine is running, if there are any malfunctions in the Hill start assist system, the warning light will illuminate. WARNING When the Hill start assist warning light illuminates, have the vehicle inspected at an authorized SUBARU dealer. Hill st ...