Subaru Crosstrek Service Manual: Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven Gear
ASSEMBLY
1. Using the ST, install the taper roller bearing (transfer case side).
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
NOTE:
Be careful when handling, because the outer race and inner race of the taper roller bearing are used as a set.
| ST 927640000 | INSTALLER |
(A) | Taper roller bearing (transfer case side) |
2. Using the ST, install the taper roller bearing (extension case side).
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
NOTE:
Be careful when handling, because the outer race and inner race of the taper roller bearing are used as a set.
| ST1 498175500 | INSTALLER |
| ST2 899864100 | REMOVER |
(A) | Taper roller bearing (extension case side) |
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the ...
Other materials:
Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor OilPROCEDURENOTE:Before making repairs, perform the oil return operation to return the compressor oil in circulation with the refrigerant to the compressor assembly.1. Increase the engine speed to 1,500 r/min.2. Turn the A/C switch to ON.3. Tu ...
Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > General DescriptionSPECIFICATIONFuel tankCapacity60 L (15.9 US gal, 13.2 Imp gal)LocationUnder rear seatFuel pumpTypeImpellerShutoff discharge pressure750 kPa (7.7 kg/cm2, 108.8 psi) or lessDischarge rate82 L (21.7 US gal, 18 Imp gal)/h or more[12.5 V at 343 ...
Installation
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnINSTALLATIONCAUTION:If the steering wheel and steering angle sensor are removed, perform the following VDC setting mode.– Model without EyeSight: VDC sensor midpoint setting mode VDC Control Module and Hydraulic Control Unit (VDCCM&H ...
