Subaru Crosstrek Service Manual: Caution
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > General Description
CAUTION
1. Never connect the battery in reverse polarity.
• Doing so may immediately damage the A/C control panel.
2. Do not disconnect the battery cables while the engine is running.
• A large counter electromotive force will be generated in the generator, and this voltage may damage electronic parts such as A/C control panel etc.
3. Before disconnecting the connectors of sensors and the A/C control panel, be sure to turn off the ignition switch.
• A/C control panel may be damaged.
4. Every A/C-related part is a precision part. Do not drop them.
5. Airbag system harness is routed near the A/C control panel and junction box.
CAUTION:
• Do not use electrical test equipment on the airbag system harness and connector.
• Be careful not to damage the airbag system harness when servicing the A/C control panel and junction box.
Preparation tool
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and t ...
Other materials:
Installation
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorINSTALLATIONCAUTION:Be careful not to damage the sensor.1. Install each part in the reverse order of removal.2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.NOTE:Check the identification (mark) on the harness to ...
Inspection locations after a collision Inspection
AIRBAG SYSTEM > Inspection Locations after a CollisionINSPECTIONIf the vehicle is involved in a collision, even if it is a slight collision, be sure to check the following systems.1. DRIVER’S AIRBAG MODULE ASSEMBLY1. Frontal collision (driver’s airbag module assembly activated)(1) Rep ...
Read diagnostic trouble code (dtc) Operation
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATIONRead out DTCs stored in the airbag system and the occupant detection system.1. AIRBAG SYSTEM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information ...
