Subaru Crosstrek Service Manual: Installation
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed Sensor
INSTALLATION
CAUTION:
Be careful not to damage the sensor.
1. Install each part in the reverse order of removal.
2. Route the rear ABS wheel speed sensor cable to the upper arm assembly.
NOTE:
Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATION">
Tightening torque:
Rear ABS wheel speed sensor: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
Rear wheel (except for C4 model): 120 N·m (12.2 kgf-m, 88.5 ft-lb)
Rear wheel (C4 model): 100 N·m (10.2 kgf-m, 73.8 ft-lb)
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorREMOVAL1. 5 DOOR MODEL1. Disconnect the ground cable from battery.2. Lift up the vehicle, and then remove the rear wheels.3. Remove the r ...
Other materials:
Dtc b2809 vdc malfunction
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2809 VDC MALFUNCTIONDetected when error occurs in the VDC. (VDC failure)When lost communication with vehicle dynamics control and vehicle dynamics control module abnormal or VDC echo back disagreement occur simul ...
Dtc p0716 input/turbine shaft speed sensor "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0716 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• No lock-up occurs.• Sho ...
Dtc b16f1 passenger s seat belt warning failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F1 PASSENGER’S SEAT BELT WARNING FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag control module is faulty.• Meter is faulty.• Harness circuits between ...
