Subaru Crosstrek Service Manual: Vehicle dynamics control (vdc)
- Abs sequence control
- Front abs wheel speed sensor
- Front magnetic encoder
- General description
- Rear abs wheel speed sensor
- Rear magnetic encoder
- Relay and fuse
- Vdc control module and hydraulic control unit (vdccm h/u)
- Vdc off switch
- Vdc sequence control
- Vehicle dynamics control system
- Yaw rate and g sensor
- Steering angle sensor Replacement
Read diagnostic trouble code (dtc) Operation
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle inform ...
Other materials:
Preparation
1. Turn off the ignition switch.
2. Close all doors (including rear gate).
3. Press and hold the " "
button on the
access key. All doors (including rear gate)
will then be locked.
4. Keep the " " button
pressed, and
press the rear lock button within 5
seconds after step ...
Removal
EXTERIOR/INTERIOR TRIM > Glove BoxREMOVALNOTE:Refer to “Security and Locks” section for key cylinder replacement. Key Lock Cylinders > REPLACEMENT">1. Remove the pocket assembly.(1) Attach the protective tape (a) to the panel center LWR.(2) Remove the damper COMPL - pocket ...
Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...
