Subaru Crosstrek Service Manual: Specification
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence Control
SPECIFICATION
1. CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROL
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
• When the speed of at least one wheel reaches 10 km/h (6 MPH).
• When the brake pedal is released during ABS sequence control and the switch - stop light becomes OFF.
• After completion of ABS sequence control.
• When a malfunction is detected.
Operation
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence ControlOPERATION1. While the ABS sequence control is being performed, the operation of the hydraulic unit can be checked using the brake tester or pres ...
Other materials:
General diagnostic table Inspection
LAN SYSTEM (DIAGNOSTICS) > General Diagnostic TableINSPECTIONItemOperationSpecificationsNoteYESNODiagnostic codeDTC is displayed when inspecting all DTCs.Perform the diagnosis according to DTC.System is normal. — SpeedometerFaster vehicle speed than the actual speed is displayed.VDC CM data may ...
Dtc p081a starter disable circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P081A STARTER DISABLE CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
Diagnostic procedure for subaru select monitor communication Communication for initializing impossible
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure for Subaru Select Monitor CommunicationCOMMUNICATION FOR INITIALIZING IMPOSSIBLEDiagnosis:Defective harness connectorTrouble symptom:Subaru Select Monitor communication failureCAUTION:Use the check board when measuring the TC ...
