VEHICLE DYNAMICS CONTROL (VDC) > Front Magnetic Encoder
INSPECTION
Visually check the magnetic encoder for any damage. If necessary, replace with a new hub unit COMPL - front axle.
NOTE:
Because the magnetic encoder is integrated with hub unit COMPL, replace the hub unit COMPL with a new part if there is any defect found on the magnetic encoder.
Screen OFF setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or "
" switch to
select the "Screen Off" item. Then push
the
button.
3. Push the
button once more.
4. The screen is turned off.
Restoring the s ...
Electrical component location Location
TELEMATICS SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Data link connector(4)Data communication module (DCM)(6)Instrument panel speaker(2)GPS antenna(5)Audio or navigation(7)Airbag CM(3)Telematics sub antenna (1)Telematics antenna(2)Door speaker (standard specification) (1) ...
Dtc p0111 intake air temperature sensor 1 circuit range/performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0111 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCE BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Improper idling• Poor d ...