Subaru Crosstrek Owners Manual: Seatbelt maintenance
To clean the seatbelts, use a mild soap and lukewarm water. Never bleach or dye the belts because this could seriously affect their strength.
Inspect the seatbelts and attachments including the webbing and all hardware periodically for cracks, cuts, gashes, tears, damage, loose bolts or worn areas.
Replace the seatbelts even if only minor damage is found.
CAUTION
- Keep the belts free of polishes, oils, chemicals and particularly battery acid.
- Never attempt to make modifications or changes that will prevent the seatbelt from operating properly.
Rear center seatbelt
Center seatbelt tongue plate
Connector (tongue)
Connector (buckle)
Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing
twisted can increase the risk or
severi ...
Front seatbelt pretensioners
The driver's and front passenger's seatbelts
have a seatbelt pretensioner. The
seatbelt pretensioners are designed to be
activated in the event of an accident
involving a moderate to severe fronta ...
Other materials:
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Switches and HarnessINSPECTION1. BACK-UP LIGHT SWITCH1. Turn the ignition switch to OFF.2. Disconnect the back light switch connector.3. Measure the resistance between the back-up light switch terminals.Gear shift positionTerminal No.Specified resistanc ...
Preparation tool
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > General DescriptionPREPARATION TOOL1. GENERAL TOOLTOOL NAMEREMARKSCircuit testerUsed for measuring resistance, voltage and current.Hexagon wrenchUsed for forcibly driving the motor assembly - sunroof. Width across flat 4 mm (0.16 in)TORX® T25Used for rem ...
Two separate circuits
Your vehicle has two separate circuit
brake systems. Each circuit works diagonally
across the vehicle. If one circuit of
the brake system should fail, the other half
of the system still works. If one circuit fails,
the brake pedal will go down much closer
to the floor than usual and you will n ...
