Subaru Crosstrek Service Manual: Preparation tool
VEHICLE DYNAMICS CONTROL (VDC) > General Description
PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION | TOOL NUMBER | DESCRIPTION | REMARKS |
—
SUBARU SELECT MONITOR 4
Used for setting of each function and troubleshooting for electrical system.
NOTE:
For detailed operation procedures of Subaru Select Monitor 4, refer to “Application help”.
2. GENERAL TOOL
TOOL NAME | REMARKS |
Circuit tester | Used for measuring resistance, voltage and current. |
DST-i | Used together with Subaru Select Monitor 4. |
Pressure gauge | Used for measuring oil pressure. |
Oscilloscope | Used for measuring the sensor. |
Steering wheel puller | Used for removing the steering wheel. |
TORX® E5 | Used for replacing the VDC control module & hydraulic control unit (VDCCM&H/U). |
Component
VEHICLE DYNAMICS CONTROL (VDC) > General DescriptionCOMPONENT1. ABS WHEEL SPEED SENSOR(1)Front ABS wheel speed sensor(4)Rear ABS wheel speed sensorTightening torque: N·m (kgf-m, ft-lb)(2)Hou ...
Other materials:
Inspection
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSPECTION1. Moving the front tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the hub unit bearing.2. Inspect ...
Note
EyeSight > Switches and HarnessNOTE1. PRE-COLLISION BRAKE OFF SWITCH & LANE DEPARTURE WARNING OFF SWITCHThe pre-collision brake OFF & lane departure warning OFF switch is integrated in the stereo camera cover assembly.If the pre-collision brake OFF & lane departure warning OFF switch ...
Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > AWD Warning Light DisplayOPERATIONAWD light illuminates or blinks, when the AWD is in special control condition and AWD has malfunction.• At normal conditionAfter turning the ignition switch to ON, illuminates for 2 seconds then goes off.&b ...
