Subaru Crosstrek Service Manual: Relay and fuse

Installation

VEHICLE DYNAMICS CONTROL (VDC) > Rear Magnetic EncoderINSTALLATIONRefer to “Rear Hub Unit Bearing” for installation, because the rear magnetic encoder is integrated with the hub unit CO ...

Inspection

VEHICLE DYNAMICS CONTROL (VDC) > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse. ...

Other materials:

State emission testing (U.S. only)
WARNING Testing of an All-Wheel Drive model must NEVER be performed on a single two-wheel dynamometer. Attempting to do so will result in uncontrolled vehicle movement and may cause an accident or injuries to persons nearby. CAUTION At state inspection time, remember to tell your inspe ...

Removal
DIFFERENTIALS > Rear Differential (T-type)REMOVAL1. Shift the select lever or gear shift lever to neutral.2. Release the parking brake.3. Disconnect the ground cable from battery.4. Lift up the vehicle.5. Remove the rear wheels.6. Drain differential gear oil. Differential Gear Oil > REPLACEME ...

Inspection
EyeSight > Switches and HarnessINSPECTION1. PRE-COLLISION BRAKE OFF SWITCH AND LANE DEPARTURE WARNING OFF SWITCH1. Measure the resistance between connector terminals.Preparation tool:Circuit tester• Pre-collision brake OFF switchTerminal No.Inspection conditionsStandard10 — 8OFFApprox. 1 ...