Subaru Crosstrek Service Manual: Specification

1. CONDITIONS FOR COMPLETION OF VDC SEQUENCE CONTROL

When the following conditions develop, the VDC sequence control stops and VDC operation is returned to the normal control mode.

• When the speed of at least one wheel reaches 10 km/h (6 MPH).

• After completion of VDC sequence control.

• When a malfunction is detected.

Operation

Vehicle dynamics control system

Other materials:

Dtc p0019 crankshaft position - camshaft position correlation bank 2 sensor b
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0019 CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION BANK 2 SENSOR BDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improp ...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transmission Control Module (TCM)REMOVAL1. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.2. Remove the instrument panel lower cover. Instrument Panel Lowe ...

Except U.S.-spec. models (type B)
The illustration above is a typical example. For some models, the combination meter may be slightly different than that shown in the illustration. Tachometer Multi information display Fuel gauge Select lever/gear position indicator Speedometer Trip meter A/B selection and trip m ...