Subaru Crosstrek Service Manual: Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > System Operation Check Mode
OPERATION
1. COMBINATION METER
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Combination Meter» and then select «Enter».
5. On «Select Function» display, select «Active Test».
6. On «Active Test» display, select an item to be checked.
NOTE:
• For detailed operation procedures, refer to “Application help”.
• If not equipped (depending on destination area or vehicle equipment condition), process will not go on.
CAUTION:
After executing the system operation check mode, execute the Clear Memory Mode. Clear Memory Mode > OPERATION">
List
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > System Operation Check ModeLIST• Combination meter (models with normal meters)Check itemItem 1Item 2NoteMeter Needle Movement CheckSpeedometerSpeed ...
User customizing
...
Other materials:
Interior light off delay timer setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Interior Light" item. Then push
the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Select ...
Removal
EXTERIOR/INTERIOR TRIM > Floor MatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
List of cancel code List
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > List of Cancel CodeLISTCodeItemContents of diagnosisB2320Rear RADAR Low Voltage (less than 9V)Temporarily stops because the voltage supplied to radar drops below 9 V. Returns to normal when the voltage becomes normal.B2321Rear RADAR Hi ...
