Subaru Crosstrek Service Manual: Wiring diagram
VEHICLE DYNAMICS CONTROL (VDC) > Vehicle Dynamics Control System
WIRING DIAGRAM
Refer to “Vehicle Dynamics Control System” in the wiring diagram. Vehicle Dynamics Control System > WIRING DIAGRAM">
Electrical specification
VEHICLE DYNAMICS CONTROL (VDC) > Vehicle Dynamics Control SystemELECTRICAL SPECIFICATIONRefer to the Control Module I/O Signal of the “Vehicle Dynamics Control System (VDC) (DIAGNOSTICS)&rdqu ...
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Vehicle Dynamics Control SystemINSPECTIONRefer to the “Vehicle Dynamics Control System (VDC) (DIAGNOSTICS)”. General Diagnostic Table > INSPECTION&q ...
Other materials:
Installation
SECURITY AND LOCKS > Body Integrated UnitINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type B” described in “REGISTRATION MANUAL ...
Tilt/telescopic steering wheel
WARNING
Do not adjust the steering wheel
tilt/telescopic position while driving.
This may cause loss of
vehicle control and result in
personal injury.
If the lever cannot be raised to
the fixed position, adjust the
steering wheel again. It is dangerous
to drive without locking
...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyADJUSTMENT1. THRUST BEARING PRELOAD1. Select a suitable adjusting washer No. 1 so that dimension (H) will be zero in a visual check. Position the washer (18.3 ? 30 ? t) and lock washer (18 ? 30 ? 2) and attach the lock nut.2. ...
