Subaru Crosstrek Service Manual: Installation
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed Sensor
INSTALLATION
CAUTION:
• Be careful not to damage the sensor.
• Do not apply excessive force to the sensor harness.
Install each part in the reverse order of removal.
NOTE:
• Check the identification (mark) on the harness to make sure there is no warpage. General Description > SPECIFICATION">
• Check if the harness is not pulled and does not come in contact with the suspension or body while operating the steering.
Tightening torque:
Front ABS wheel speed sensor: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
Front ABS wheel speed sensor bracket: 33 N·m (3.4 kgf-m, 24.3 ft-lb)
Front wheel: Except for C4 model
120 N·m (12.2 kgf-m, 88.5 ft-lb)
Front wheel: C4 model
100 N·m (10.2 kgf-m, 73.8 ft-lb)
Removal
VEHICLE DYNAMICS CONTROL (VDC) > Front ABS Wheel Speed SensorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the front wheels.3. Remove th ...
Other materials:
Read cancel code Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, sele ...
Alarm system operation
When the Subaru Ascent alarm system is armed, it will be triggered if any of
the following components are opened without authorization:
Any door
The rear gate
The engine hood
Once triggered, the Subaru Ascent alarm system will activate the following alerts:
The horn will sound conti ...
Dtc c1231 rear right abs sensor circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1231 REAR RIGHT ABS SENSOR CIRCUITNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) & ...
