Subaru Crosstrek Service Manual: Note

For operation procedures of each component of the vehicle dynamics control system, refer to the respective section.

• VDC control module & hydraulic control unit (VDCCM&H/U): VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)">

• Yaw rate & G sensor: Yaw Rate and G Sensor">

• Steering angle sensor: Steering Angle Sensor">

• Front ABS wheel speed sensor: Front ABS Wheel Speed Sensor">

• Rear ABS wheel speed sensor: Rear ABS Wheel Speed Sensor">

• Front magnetic encoder: Front Magnetic Encoder">

• Rear magnetic encoder: Rear Magnetic Encoder">

• VDC OFF switch: VDC OFF Switch">

Inspection

Yaw rate and g sensor

Other materials:

System maintenance
NOTE For the Subaru Ascent remote engine starter transceiver: if the vehicle battery has been replaced, discharged, or disconnected, it is necessary to start the vehicle manually at least once using the key or ignition system before the remote engine start function can be used again. This ste ...

Caution
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMThe airbag system wiring harness is routed near the power steering control module.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses or connector circui ...

Front passenger's frontal airbag ON and OFF indicators
Front passenger's frontal airbag ON indicator Front passenger's frontal airbag OFF indicator The front passenger's frontal airbag ON and OFF indicators show you the status of the front passenger's SRS frontal airbag. The indicators are located next to the clock in the center po ...