Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Screen Settings

After entering the "Screen Settings" menu, select one of the following menus.

Welcome Good-bye Screen

The welcome screen/good-bye screens can be activated or deactivated. Select "On" to activate the screens. Select "Off" to deactivate the screens.

Gauge Initial Movement

The movement of the meter needles and gauge needles that occurs when the ignition switch is turned to the "ON" position can be activated or deactivated.

Select "On" to activate. Select "Off" to deactivate.

Languages

Operate the "  " or " " switch on the steering wheel to display the preferred language. Then pull the "  /SET" switch to select the displayed language.

Menu screens
Pull the " /SET" switch to enter the menu screens when all of the following conditions are satisfied. The vehicle has been completely stopped. The select lever is in the "P" position. ...

EyeSight (models with EyeSight system)
NOTE For models with the EyeSight system, refer to the Owner's Manual supplement for the EyeSight system. BSD/RCTA (if equipped) After entering the "BSD/RCTA" menu, select the "Warning Volume" m ...

Other materials:

Dtc p0138 o2 sensor circuit high voltage bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0138 O2 SENSOR CIRCUIT HIGH VOLTAGE BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...

Inspection
CONTROL SYSTEMS > MT Gear Shift LeverINSPECTION1. Check the parts (bushing, cushion rubber, spacer, boot, stay and rod, etc.) for deformation, damage and wear. If necessary, correct or replace faulty parts. Compare the removed parts with new parts to judge if there are damages or not.(A)Bushing(B ...

Removal
LIGHTING SYSTEM > Back-up Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...

© 2016-2026 Copyright www.sucross.com