Subaru Crosstrek Owners Manual: EyeSight (models with EyeSight system)
NOTE
For models with the EyeSight system, refer to the Owner's Manual supplement for the EyeSight system.
BSD/RCTA (if equipped)
After entering the "BSD/RCTA" menu, select the "Warning Volume" menu. You can set the volume of the warning buzzer for RCTA (Rear Cross Traffic Alert). You can select "Max", "Mid", "Min" or "Off".
Default Settings
Select "Yes" to use the menu screen to restore customized settings to the factory default settings. Select "No" to return to the previous screen without restoring the factory default settings.
Screen Settings
After entering the "Screen Settings" menu,
select one of the following menus.
Welcome Good-bye Screen
The welcome screen/good-bye screens
can be activated or deactivated. Select
"On" to activate ...
Other materials:
Inspection
LIGHTING SYSTEM > Room LightINSPECTION1. ROOM LIGHT BULB1. Visually check the bulb for blow out.2. Check the bulb specification. General Description > SPECIFICATION">3. Replace the bulb if it is found defective.2. ROOM LIGHT SWITCH1. Check the resistance between switch terminals.Prepa ...
Inspection
LUBRICATION(H4DO) > Oil Level SwitchINSPECTION1. INSPECTION WHEN LOW ENGINE OIL WARNING LIGHT IS ILLUMINATEDSTEPCHECKYESNO1.CHECK ENGINE OIL LEVEL.Is engine oil level normal? Oil Level Switch > INSPECTION">Go to Step 2.Replace engine oil or refill, and check again while the oil level i ...
Installation
REAR SUSPENSION > Rear Trailing LinkINSTALLATIONCAUTION:• Be sure to use a new self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.1. Install each part in the reverse order of removal.Tighten ...
