Subaru Crosstrek Owners Manual: Menu screens

Subaru Crosstrek Owners Manual / Instruments and controls / Multi information display (models with type B combination meter) / Menu screens

Pull the " /SET" switch to enter the menu screens when all of the following conditions are satisfied.

The vehicle has been completely stopped.
The select lever is in the "P" position.
The menu screen entering screen is selected.
The " " information reminder is off.

The menu list is as follows.

First menu	Second menu
Screen Settings	Welcome Good-bye Screen
	Gauge Initial Movement
	Languages
	Go Back
EyeSight (models with EyeSight system)	Warning Volume
	Lead Vehicle Acquisition Sound
	Lead Vehicle Moving Monitor Function
	Go Back
BSD/RCTA (if equipped)	Warning Volume
Default Settings	―

By operating the " " or " " switch on the steering wheel, you can select the menu.

Pull the " /SET" switch to enter the selected menu.

NOTE

If you enter the "Go Back" menu, the system will return to the previous screen.

Basic screens

By operating the " " or " " switch on the steering wheel, you can change the screen that is always displayed. Default screen Digital speedometer Menu screen entering scree ...

Screen Settings

After entering the "Screen Settings" menu, select one of the following menus. Welcome Good-bye Screen The welcome screen/good-bye screens can be activated or deactivated. Select "On" to activate ...

Other materials:

Certification for the Hands-free system
This device complies with Part 15 of FCC Rules and Industry Canada's licenceexempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause u ...

Dtc b16f1 passenger s seat belt warning failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B16F1 PASSENGER’S SEAT BELT WARNING FAILUREDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag control module is faulty.• Meter is faulty.• Harness circuits between ...

Preparation for screen settings
1. Turn the ignition switch to the "ON" position. 2. Push and hold the button to show the selection screen. 3. After the selection screen is displayed, operate the " " or " " switch to show the "Screen Setting" item. Then, push the button. ...