Subaru Crosstrek Service Manual: Vdc off switch

Removal

VEHICLE DYNAMICS CONTROL (VDC) > VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)REMOVAL1. MODELS WITHOUT EyeSight1. Disconnect the ground cable from battery. NOTE">2. Remove ...

Inspection

VEHICLE DYNAMICS CONTROL (VDC) > VDC OFF SwitchINSPECTION1. Disconnect the VDC OFF switch connector.2. Check the resistance between the VDC OFF switch terminals.PREPARATION TOOL:Circuit testerTermi ...

Other materials:

Safety tips regarding the BSD/RCTA approach indicator light/warning buzzer
In the following cases, operation of the BSD/RCTA approach indicator light and the warning buzzer may be delayed or the system may fail to issue these warnings. When a vehicle moves to the neighboring lane from a lane next to the neighboring lane When driving on a steep incline or on ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearINSTALLATION1. Install the reverse shifter lever, adjusting washer, reverse idler gear, reverse idler gear shaft and washer, and secure them with the straight pin.NOTE:• Be sure to install the reverse idler gear shaft from rear s ...

Rear seatbelts (except rear center seatbelt)
1. Sit well back in the seat. 2. Pick up the tongue plate and pull the belt out slowly. Do not let it get twisted. If the belt stops before reaching the buckle, return the belt slightly and pull it out more slowly. If the belt still cannot be unlocked, let the belt retract slightly a ...