Subaru Crosstrek Service Manual: Caution

• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing any work.

• Remove contamination including dirt and corrosion before removal, installation or disassembly.

• Keep the disassembled parts in order and protect them from dust and dirt.

• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly and replacement.

• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or manufacturers.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Place shop jacks or rigid racks at the specified points.

• Apply grease onto sliding or revolving surfaces before installation.

• Before installing O-rings or snap rings, apply sufficient amount of fluid to avoid damage and deformation.

• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth between the part and the vise.

• Before disconnecting electrical connectors, be sure to disconnect the negative terminal from battery.

General description

Specification

Other materials:

Vehicle capacity weight
Vehicle placard The cargo capacity of the Subaru Ascent is determined by weight rather than available space. The maximum permissible load is indicated on the vehicle placard located on the driver’s side door pillar. This value includes the combined weight of the driver, passengers, c ...

Dtc b14eb intake door actuator stuck
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14EB INTAKE DOOR ACTUATOR STUCKDTC detecting condition:• Intake door actuator is locked.• The potentiometer value of the actuator does not change.Trouble symptom:FRESH/RECIRC does not op ...

Bypass screen setting
1. Perform the preparation steps according to "Preparation for screen settings" 2. Operate the " " or "  " switch to select the "Bypass Screen" item. Then push the button. 3. Select the item to set by operating the "  " or " " switches. Then push the button ...