Subaru Crosstrek Service Manual: Control systems
- At shift lock control system
- At shift lock solenoid and p range switch
- General description
- Mt gear shift lever
- Select cable
- Select lever
- Body integrated unit Note
- General diagnostic table Inspection
Transfer clutch pressure test Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Clutch Pressure TestINSPECTIONCAUTION:• Directly after the vehicle has been running or the engine has been idling for a long time, the CVT ...
Other materials:
Inspection
WIPER AND WASHER SYSTEMS > Combination Switch (Wiper)INSPECTION1. INSPECTION OF SWITCH UNIT1. Operate the switches to check the continuity between terminals. Switch positionTerminal No.StandardFrontOFFA1 and A3Less than 1 ?INTA1 and A3Less than 1 ?LOA2 and A3Less than 1 ?HIA2 and A4Less than 1 ?W ...
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Yaw Rate and G SensorINSPECTION1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNALSTEPCHECKYESNO1.CHECK YAW RATE & G SENSOR.1) Check the installation condition of the VDC control module & hydraulic control module (VDCCM&H/U).2) Using the Subar ...
Initial screen
When the ignition switch is in the "ACC" or
"ON" position, the initial screen will be
displayed and the system will begin
operating.
When using the SUBARU STARLINK
function (if equipped), the display screen
may be different from the screen above.
After a few seconds, the caution scr ...
