Subaru Crosstrek Service Manual: Select cable

Installation

CONTROL SYSTEMS > MT Gear Shift LeverINSTALLATION1. Insert the gear shift lever from the room side.NOTE:Insert the rod and the stay, and then temporarily set them onto the transmission mount.2. Lif ...

Adjustment

CONTROL SYSTEMS > Select CableADJUSTMENT1. Shift the select lever to “N” range.2. Lift up the vehicle.3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">4. Re ...

Other materials:

Installation
EXTERIOR/INTERIOR TRIM > Rear Gate GarnishINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse order of removal.Tightening torqueGarnish assembly - rear gate: 4.5 N·m (0.46 kgf-m, 3.3 f ...

Map lights
Type A Type B To turn on the map light, push the switch. To turn it off, push the switch again. NOTE For the type A map lights, although the light switches are in the ON position, the lights are automatically turned off after approximately 30 seconds of illumination to prevent the veh ...

Check list for interview Check
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Check List for InterviewCHECKCheck the following item about the vehicle’s state.1. STATE OF ABS WARNING LIGHTABS warning light illuminates. Always Sometimes Only once Does not illuminate• When/How long does it illuminate?Ignition key posit ...