Subaru Crosstrek Service Manual: Inspection
CONTROL SYSTEMS > Select Cable
INSPECTION
Check the removed cable and replace or adjust if damaged, rusty or malfunctioning.
1. Check the cable for smooth operation.
2. Check the inner cable for damage and rust.
3. Check the outer cable for damage, bends and cracks.
4. Check the boot for damage, cracks and deterioration.
5. Move the select lever from “P” to “D” range. Check the existence of feel to contact the detents in each range. If the detents cannot be felt or the position pointer is improperly aligned, adjust the cable.
6. Check if the starter motor rotates when the select lever is set to “P” range.
7. Check the back-up light illumination when the select lever is in “R” range.
8. Check the parking lock operation when the select lever is in “P” range.
Removal
CONTROL SYSTEMS > Select CableREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect th ...
Installation
CONTROL SYSTEMS > Select CableINSTALLATION1. Position the select cable as shown in the figure, and install it to the plate assembly.CAUTION:• If the cable is installed in the wrong direction, ...
Other materials:
Inspection
IGNITION(H4DO) > Spark PlugINSPECTION1. Check the spark plug for abnormalities. If defective, replace the spark plug.(A)Terminal damage(B)Crack or damage in insulator(C)Damaged gasket2. Check the spark plug electrode and condition of the insulator. If abnormal, check and repair the cause and repl ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Tank ProtectorINSTALLATIONInstall in the reverse order of removal.NOTE:Use a new self-locking nut.Tightening torque:T1: 9 N·m (0.9 kgf-m, 6.6 ft-lb) T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)(A)Self-locking nut ...
Removal
CONTROL SYSTEMS > Select LeverREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.3. Lift up the vehicle.4. Remove the center exhaust pipe. Cen ...
