Subaru Crosstrek Service Manual: General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic Table
INSPECTION
Symptoms | Possible cause | Corrective action |
Select lever | Starter does not run. | Adjust the select cable and inhibitor switch, or inspect the circuit. |
Back-up light does not illuminate. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
AT shift lock system does not operate normally. | Adjust the select cable and inhibitor switch, or inspect the circuit. | |
Manual mode can not be set. | Inspect the mode switch and select lever, or inspect the circuit. | |
Up-shift is not engaged at manual mode. | Check the shift-up switch and circuit. | |
Down-shift is not engaged at manual mode. | Check the shift-down switch and circuit. |
Body integrated unit Note
CONTROL SYSTEMS > Body Integrated UnitNOTERefer to “Body Integrated Unit” for removal and installation procedure. Body Integrated Unit"> ...
Cooling(h4do)
...
Other materials:
Inspection
MECHANICAL(H4DO) > Cylinder BlockINSPECTION1. CYLINDER BLOCK & PISTON1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sections to check for fissures.3. Check that there are no traces of gas leaking or water le ...
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the back-up light switch and the neutral position switch. Switches and Harness > REMOVAL">3. ...
Activation of malfunction indicator light
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightACTIVATION OF MALFUNCTION INDICATOR LIGHT1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the combination meter illuminates.NOTE:If the malfunction indicator light does not illuminate, perform ...
