Subaru Crosstrek Service Manual: Body integrated unit Note
CONTROL SYSTEMS > Body Integrated Unit
NOTE
Refer to “Body Integrated Unit” for removal and installation procedure. Body Integrated Unit">
Installation
CONTROL SYSTEMS > Select LeverINSTALLATION1. Set the select lever assembly to the vehicle body.2. Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.Tightening ...
General diagnostic table Inspection
CONTROL SYSTEMS > General Diagnostic TableINSPECTIONSymptomsPossible causeCorrective actionSelect leverStarter does not run.Adjust the select cable and inhibitor switch, or inspect the circuit.Back ...
Other materials:
Safety precautions
WARNING
Never attempt to remove the radiator
cap until the engine has been
shut off and has cooled down
completely. Since the coolant is
under pressure, you may suffer
serious burns from a spray of boiling
hot coolant when the cap is
removed.
CAUTION
Vehicles are filled at the factory
...
Dtc b1802 short in driver s airbag (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1802 SHORT IN DRIVER’S AIRBAG (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Airbag module harness (driver&rsq ...
Dtc p2420 evap system switching valve control circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2420 EVAP SYSTEM SWITCHING VALVE CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > ...
