Subaru Crosstrek Service Manual: Inspection
CONTROL SYSTEMS > Select Lever
INSPECTION
1. Inspect the removed parts by comparing with new parts for deformation, damage and wear. Repair or replace if defective.
2. Inspect the select lever assembly operating condition before assembly. Normal if it operates smoothly.
Disassembly
CONTROL SYSTEMS > Select LeverDISASSEMBLY1. GRIP ASSY1. Remove the button assembly_AT.(A)Claw2. Remove the rod COMPL.2. AT SELECT LEVER ASSEMBLY1. Remove the spacer plate.2. Remove the gasket.3. In ...
Installation
CONTROL SYSTEMS > Select LeverINSTALLATION1. Set the select lever assembly to the vehicle body.2. Tighten the four mounting bolts to attach the select lever assembly to the vehicle body.Tightening ...
Other materials:
Electrical component location Location
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Headlight ASSY– Headlight beam leveler actuator(4)Headlight relay (Hi)(7)Combination meter(2)Rear vehicle height sensor(5)Body integrated unit(8)Fuse 10 A (auto headlight beam leveler CM)(3)Headlight rel ...
Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > System Operation Check ModeOPERATION1. COMBINATION METER1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System». ...
Disassembly
DRIVE SHAFT SYSTEM > Front Drive ShaftDISASSEMBLY1. Place alignment marks on the shaft and outer race (PTJ).2. Remove the boot band and boot (PTJ).CAUTION:Be careful not to damage the boot.3. Remove the snap ring from outer race (PTJ).4. Remove the outer race (PTJ) from shaft assembly.5. Wipe off ...
