PERIODIC MAINTENANCE SERVICES > Cooling System
INSPECTION
1. RADIATOR
Check that there are no engine coolant leaks from the hose connections. Refer to “CO” section for radiator inspection. Radiator > INSPECTION">
2. RADIATOR CAP
Refer to “CO” section for radiator cap inspection. Radiator Cap > INSPECTION">
3. COOLING FAN
Refer to “CO” section for cooling fan inspection. Radiator Fan System > INSPECTION">
4. COOLING SYSTEM
Start the engine, and then inspect that it does not overheat or it is not cooled excessively. If it overheats or it is cooled excessively, check the cooling system.
Clutch system Inspection and adjustment
Disc brake pad and disc InspectionDtc c2123 transmitter 3 no data
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2123 TRANSMITTER 3 NO DATANOTE:Refer to DTC C2124 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2124 TRANSMITTER 4 NO DATA"> ...
Dtc p2271 o2 sensor signal biased/stuck rich bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2271 O2 SENSOR SIGNAL BIASED/STUCK RICH BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Me ...
Inspection
EyeSight > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsS ...