Subaru Crosstrek Service Manual: Rear magnetic encoder

Installation

VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorINSTALLATIONCAUTION:Be careful not to damage the sensor.1. Install each part in the reverse order of removal.2. Route the rear ABS wheel ...

Inspection

VEHICLE DYNAMICS CONTROL (VDC) > Rear Magnetic EncoderINSPECTIONVisually check the magnetic encoder parts for any damage. If necessary, replace with a new hub unit COMPL - rear axle.NOTE:Because th ...

Other materials:

Dtc u0422 invalid data received from body control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from body integrated unit.TROUBLE SYMPTOM:Cooperation control with body integrated unit does not operate ...

Dtc p2530 ignition switch run position circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Cl ...

Parking brake stroke
Check the parking brake stroke according to the maintenance schedule in the "Warranty and Maintenance Booklet". When the parking brake is properly adjusted, braking power is fully applied by pulling the lever up 7 to 8 notches gently but firmly (approximately 45 lbf [200 N, 20.4 kgf]). ...