VEHICLE DYNAMICS CONTROL (VDC) > Rear Magnetic Encoder
INSPECTION
Visually check the magnetic encoder parts for any damage. If necessary, replace with a new hub unit COMPL - rear axle.
NOTE:
Because the magnetic encoder is integrated with hub unit COMPL, replace the hub unit COMPL with a new part if there is any defect found on the magnetic encoder.
RemovalDtc u0428 invalid data received from steering angle sensor module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0428 INVALID DATA RECEIVED FROM STEERING ANGLE SENSOR MODULEDTC DETECTING CONDITION:Defective data was transmitted from steering angle sensor.TROUBLE SYMPTOM:VDC CM does not operate normally.STEPCHECKYESNO1.CHE ...
Fuel system trouble in general Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel System Trouble in GeneralINSPECTIONTroublePossible causeCorrective actionInsufficient fuel supply to fuel injectora. Fuel pump does not operate. Defective terminal contactInspect contact, especially ground, and tighten it securely. Trouble in elec ...
Dtc p0111 intake air temperature sensor 1 circuit range/performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0111 INTAKE AIR TEMPERATURE SENSOR 1 CIRCUIT RANGE/PERFORMANCE BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Improper idling• Poor d ...