Subaru Crosstrek Service Manual: Transfer driven gear

Subaru Crosstrek Service Manual / Manual transmission and differential(5mt) / Transfer driven gear

Installation

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearINSTALLATION1. Install the transfer drive gear.Tightening torque:26 N·m (2.7 kgf-m, 19.2 ft-lb)2. Select the adjusting washer. ...

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearASSEMBLY1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, ...

Other materials:

Assembly
DIFFERENTIALS > Rear Differential (VA-type)ASSEMBLYNOTE:• Assemble in the reverse order of disassembly.• Check and adjust each part during assembly.• Keep the shims and washers in order, so that they are not improperly installed.• Thoroughly clean the surfaces on which the ...

Removal
LIGHTING SYSTEM > Front Side Marker Light BulbREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Turn the steering wheel in the opposite direction from the parts to be removed. Then remove the clips and turn over the mud guard - front.3. Remove the bulb socket and front side ma ...

Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyASSEMBLY1. When the sleeve & hub assemblies have been disassembled, reassemble by aligning the alignment marks.NOTE:Position the open ends of the spring 120° apart.(A)3rd-4th coupling sleeve & synchronizer hub ASSY( ...