Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive Gear
INSTALLATION
1. Install the transfer drive gear.
Tightening torque:
26 N·m (2.7 kgf-m, 19.2 ft-lb)
2. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION">
3. Install the transfer driven gear.
4. Install the transfer case and the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION">
5. Install the back-up light switch and the neutral position switch. Switches and Harness > INSTALLATION">
6. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION">
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearINSPECTION1. Ball bearingReplace the bearings in the following cases.• In case of broken or rusty bearings• In case of wor ...
Other materials:
Installation
SEATS > Seat Heater SystemINSTALLATIONCAUTION:• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.• When replacing the seat cover, be careful not to damage the occupant detection sensor while installing the ho ...
Dtc p0506 idle control system rpm - lower than expected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0506 IDLE CONTROL SYSTEM RPM - LOWER THAN EXPECTEDDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start the engine.• Engine does not ...
Installation
AIRBAG SYSTEM > Passenger’s Airbag ModuleINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do not allow harness and ...
