Subaru Crosstrek Service Manual: Installation

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• Do not allow harness and connectors to interfere or get tangled up with other parts.

• When reusing the tether clip on the upper part of the trim panel - front pillar UPR, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel - front pillar UPR may come off.

1. Before installation, inspect the following items and replace any faulty part with a new one.

• Passenger’s airbag lid (instrument panel surface) is cracked or deformed.

• Airbag module is cracked or deformed.

• Harness and/or connector is cracked, deformed or open.

• Harness wire is exposed.

• Mounting bracket is cracked or deformed.

2. Install the remaining parts in the reverse order of removal.

Tightening torque:

Knee airbag module: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Refer to the installation procedure of the “Instrument Panel Assembly”. Instrument Panel Assembly > INSTALLATION">

Passenger s airbag module

Removal

Other materials:

Dtc p0751 shift solenoid "a" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0751 SHIFT SOLENOID "A" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Shift control malfunc ...

Dtc c1811 system
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1811 SYSTEMDTC detecting condition:ABS and VDC long time sequential controlTrouble symptom:• ABS does not operate.• VDC does not operate.• EBD may not operate.• Hill ...

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the extension case and transmission hanger.NOTE:The total number of extension case mounting bolts is 13.3. Remove ...