Subaru Crosstrek Service Manual: Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive Gear
ASSEMBLY
1. Set the ST against the inner race of the ball bearing, and install the transfer drive gear.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
NOTE:
Use a new ball bearing.
| ST 398177700 | INSTALLER |
2. Install the snap ring on the transfer drive gear.
3. Inspect the clearance between the snap ring and the ball bearing. Transfer Drive Gear > INSPECTION">
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Drive GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the ...
Other materials:
Engine oil
CAUTION
If the level gauge cannot be
pulled out easily, twist the level
gauge right and left, then gently
pull it out. Otherwise, you may be
injured accidentally straining
yourself.
Use only engine oil with the
recommended grade and viscosity.
Be careful not to spill engine oil
...
Caution
CLUTCH SYSTEM > General DescriptionCAUTION• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassembled parts in order and protect them from dust and dirt.• Before removal, installation or disassembly, be sure to clarify ...
Operating tips for heater and air conditioner
Cleaning ventilation grille
Front ventilation inlet grille
To maintain optimal performance of the Subaru Ascent climate system, always keep
the ventilation inlet grille free from snow, debris, leaves, or dirt. Blockages
can reduce heating efficiency and impair defrosting capability.
...
