CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC U1433 INVALID DATA RECEIVED FROM EyeSight
NOTE:
Refer to “LAN SYSTEM (DIAGNOSTICS)” for diagnostic procedure. Basic Diagnostic Procedure">
1. OUTLINE OF DIAGNOSIS
• Detect malfunction of CAN communication.
• Judge as NG when data received from the stereo camera is not normal.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
12 V battery system voltage | ≥ 10 V |
Measured turbine shaft speed | > 0 rpm |
or | |
Transmission range | Drive or Reverse |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
CAN data from stereo camera | Freeze |
Time Needed for Diagnosis: 2 seconds
Malfunction Indicator Light Illumination: Does not illuminate.
Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
Dtc p170a l-range switchDisassembly
LIGHTING SYSTEM > Headlight AssemblyDISASSEMBLY1. HID HEADLIGHT BALLASTCAUTION:Do not leave the light assembly - head without the ballast - headlight for a long time. Dust, moisture, etc. entering the light assembly - head may affect its performance.1. Remove the cover - headlight.2. Disconnect t ...
Installation
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Heater Vent DuctINSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reve ...
Dtc b1013 ignition power
BODY CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1013 IGNITION POWERDTC detecting condition:Voltage failure caused by poor contact of IGN power supply circuitsTrouble symptom:Symptoms such as shift lock or wiper not operating may occur.Wiring diagram ...