Subaru Crosstrek Service Manual: Dtc p170a l-range switch
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC P170A L-RANGE SWITCH
DTC DETECTING CONDITION:
Immediately at fault recognition
NOTE:
Refer to “DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE” for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE">
1. OUTLINE OF DIAGNOSIS
• Detect the GND-output short (ground-fault) in L range SW circuit.
• Judge as NG if the L range SW is ON in P, R or N range.
2. EXECUTION CONDITION
Secondary parameters | Execution condition |
None |
3. DIAGNOSTIC METHOD
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
Malfunction Criteria | Threshold Value |
L range SW status in other than D range | ON |
Time Needed for Diagnosis: 5 s
Malfunction Indicator Light Illumination: Does not illuminate.
Dtc u1433 invalid data received from eyesight
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1433 INVALID DATA RECEIVED FROM EyeSightNOTE:Refer to “LAN SYSTEM (DIAGNOSTICS)& ...
Dtc u0100 lost communication with ecm/pcm a
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”NOTE:Refer to “LAN SYSTEM (D ...
Other materials:
Welcome lighting function (if
equipped)
The welcome lighting function turns on the
low beam headlight for smooth approaching
to or exiting from the vehicle at night or
in a dark place.
The function is activated while all of the
following conditions are met.
The light control switch is in the
"AUTO" position
It is dark enoug ...
Disassembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterDISASSEMBLYCAUTION:The starter should be placed through a no-load test whenever it has been overhauled.1. Disconnect the cable from the magnet switch assembly.2. Remove the magnet switch assembly from the starter housing assembly.3. Remove screws (A) of th ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position SensorREMOVAL1. INTAKE SIDE1. Disconnect the ground cable from battery.2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the camshaft position sensor, and remove the cam ...
