Subaru Crosstrek Service Manual: Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft Assembly
REMOVAL
1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">
2. Remove the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > REMOVAL">
3. Remove the transmission case. Transmission Case > REMOVAL">
4. Remove the drive pinion shaft assembly.
NOTE:
Use a hammer handle, etc. to remove if too tight.
(A) | Main shaft ASSY |
(B) | Drive pinion shaft assembly |
5. Remove the main shaft assembly. Main Shaft Assembly > REMOVAL">
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyADJUSTMENT1. THRUST BEARING PRELOAD1. Select a suitable adjusting washer No. 1 so that dimension (H) will be zero in a visual ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyASSEMBLY1. Install the sleeve and the gear and hub assembly by matching the alignment marks.NOTE:• Make sure that there ...
Other materials:
Basic diagnostic procedure Procedure
AIRBAG SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURESTEPCHECKYESNO1.CHECK WARNING LIGHT.Check whether the airbag warning light in the combination meter is lit.Does the airbag warning light illuminate? Basic Diagnostic Procedure > PROCEDURE">Go to Step 2.Perform the diagnos ...
Dtc b28b6 pre-collision off switch
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B28B6 PRE-COLLISION OFF SWITCHDetected when pre-collision brake OFF switch circuit is not installed, open-circuited or is stuck to ON.DTC detecting condition:• Wiring of pre-collision brake OFF switch is not ...
Operation
Driver's side
Passenger's side
SRS AIRBAGs deploy as soon as a collision occurs.
After deployment, SRS AIRBAGs start to deflate immediately so that the
driver's vision is not
obstructed.
The SRS airbags can function only when
the ignition switch is in the "ON" position.
Th ...
