Subaru Crosstrek Service Manual: Drive pinion shaft assembly

Replacement

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Differential Side Retainer Oil SealREPLACEMENT1. Disconnect the ground cable from battery.2. Remove the front tires.3. Lift up the vehicle.4. Using the T ...

Adjustment

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Drive Pinion Shaft AssemblyADJUSTMENT1. THRUST BEARING PRELOAD1. Select a suitable adjusting washer No. 1 so that dimension (H) will be zero in a visual ...

Other materials:

Dtc c1732 lateral g sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1732 LATERAL G SENSORDTC detecting condition:Defective lateral G sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.ST ...

Initial screen
When the ignition switch is in the "ACC" or "ON" position, the initial screen will be displayed and the system will begin operating. When using the SUBARU STARLINK function (if equipped), the display screen may be different from the screen above. After a few seconds, the caution scr ...

Installation
LUBRICATION(H4DO) > Oil Level SwitchINSTALLATION1. Install the oil level switch and the clip (A) to the oil pan upper.NOTE:• Use new O-rings.• Apply a coat of engine oil to the O-rings.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the engine mounting LH onto the en ...