Subaru Crosstrek Service Manual: Read cancel code Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Engine Control System».

5. Drive vehicle at 40 km/h (25 MPH) or more and set the cruise control.

CAUTION:

• When performing diagnosis, observe the legal speed limit on the road.

• The cancel code will also appear when the cruise control is cancelled by the driver’s operation. Do not confuse them.

• Be sure to get an assistant to support the diagnosis while driving, and have him/her operate the select monitor.

6. When the set speed is cancelled by itself (when cancelled without a cancel operation such as applying the brake) or if the cruise control could not be set by performing the setting operation, selecting the «Cancel Code» on the engine malfunction diagnosis screen will display the cancel code on the select monitor display.

NOTE:

The «Current» and «The past» are contained in the cancel code. The latest code recognized during current test drive is displayed in «Current». Cancel codes resulting from fault diagnosis of switches relating to the system and cruise control are also displayed in «The past».

7. Perform Engine DTC Clear Memory operation. Clear Memory Mode > OPERATION">

Cancel codes for switches relating to the system and cruise control are deleted by clearing memory on the engine side.

NOTE:

• The latest code will be cleared by turning ignition switch to OFF.

• For detailed operation procedures, refer to “Application help”.

• For details on cancel codes, refer to List of Cancel Code. List of Cancel Code">

List of cancel code List

Real-time diagnosis Operation

Other materials:

Assembly
BRAKE > Rear Disc Brake AssemblyASSEMBLY1. Before installation, check each part. Rear Disc Brake Assembly > INSPECTION">2. Clean the inside of the caliper body cylinder using brake fluid.3. Apply a coat of brake fluid to piston seal and install the piston seal to the caliper body cyli ...

Locking and unlocking
Release button Mechanical key While pressing the release button of the access key, take out the mechanical key. Lock or unlock the driver's door with the mechanical key in the procedure described in "Locking and unlocking from the outside" F2-5. NOTE After locking or unlocking, ...

Dtc p060a internal control module monitoring processor performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P060A INTERNAL CONTROL MODULE MONITORING PROCESSOR PERFORMANCENOTE:For the diagnostic procedure, refer to DTC P0606. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0606 CONTROL MODULE PROCE ...