Subaru Crosstrek Service Manual: Real-time diagnosis Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Real-time Diagnosis
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Engine Control System» and then «Enter».
5. On «Select Function» display, select «Data Monitor».
6. Make sure that normal display is shown when operated as follows:
• Depress and release the brake pedal. (Stop light switch and brake switch are turned ON.)
• Turn the “CRUISE” switch to ON.
• Turn the “CANCEL” switch to ON.
• Turn the “SET/−” switch to ON.
• Turn the “RES/+” switch to ON.
• Depress or release the clutch switch.
• Place the shift lever in any position other than neutral.
NOTE:
For detailed operation procedures, refer to “Application help”.
Read cancel code Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «C ...
Subaru select monitor Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. GENERAL DESCRIPTIONThe on-board diagnosis function of the cruise control system uses Subaru Select Monitor.The on-board diagno ...
Other materials:
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Secondary Pressure SensorREMOVALCAUTION:• Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.• When secondary pressure sensor is removed, CVTF leak ...
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof AssemblyINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• For installati ...
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyADJUSTMENT1. Install the thrust bearing to the internal gear.NOTE:Face the temper color surface to the reverse brake side.2. Measure depth “A” from the ST upper face to the washer mounting surface.ST 499575600GAUGE3 ...
