Subaru Crosstrek Service Manual: Subaru select monitor Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Subaru Select Monitor
OPERATION
1. GENERAL DESCRIPTION
The on-board diagnosis function of the cruise control system uses Subaru Select Monitor.
The on-board diagnosis function operates in two categories, which are used depending on the type of problems;
1. Cruise Control Cancel Conditions Diagnosis:
(1) This category of diagnosis requires actual vehicle driving in order to determine the cause, as when cruise speed is cancelled during driving although cruise cancel condition is not entered.
(2) Cruise control memory in ECM stores the cancel code which occurred during driving. When there are multiple cancel code, they are shown on the Subaru Select Monitor.
CAUTION:
• The cruise control memory stores not only the cruise “cancel” which occurred (although “cancel” operation is not entered by the driver), but also the “cancel” condition input by the driver.
• The content of the latest memory (the latest code) is cleared when the ignition switch is turned to OFF. However, memory contents set by the diagnosis of faulty switches related to the system and cruise control will remain as trouble history (memory code) after the ignition switch is turned to OFF.
2. Real-time Diagnosis:
Real-time diagnosis function is used to determine whether or not the input signal system is in good order, according to signal emitted from switches, sensors, etc.
(1) Vehicle cannot be driven at cruise speed when the problem occurs in the cruise control system or relevant circuits.
(2) Monitor the signal conditions from switches and sensors.
2. BASIC OPERATION
For detailed operation procedures, refer to “Application help”.
Real-time diagnosis Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Real-time DiagnosisOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select ...
Other materials:
SRS airbag system warning light
WARNING
If the SRS airbag system warning light in your Subaru Ascent shows any abnormal
behavior, immediately stop the vehicle in a safe location and contact an authorized
SUBARU dealer for inspection. Failure to properly diagnose and repair the system
may result in the seatbelt pretensioners ...
Turn off display of driving information
display
The driving information display can be
turned off.
To turn off the display, turn the ignition
switch to the "LOCK"/"OFF" position and
press the "+" button adjacent to the clock
display for approximately 5 seconds.
Then, the driving information display and
the clock display will blink for ...
Starting engine
CAUTION
Do not operate the starter motor
continuously for more than 10 seconds.
If the engine fails to start after
operating the starter for 5 to 10
seconds, wait for 10 seconds or
more before trying again.
NOTE
It may be difficult to start the engine
when the battery has been disconnecte ...
