Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Manual transmission assembly

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined sec ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Manual Transmission AssemblyINSTALLATION1. Replace the differential side retainer oil seal. Differential Side Retainer Oil Seal > REPLACEMENT"&g ...

Other materials:

Assembly
SEATS > Front SeatASSEMBLYCAUTION:• Do not confuse the harness routing of the side airbag harness and the seat belt inner - front harness, etc. Assembling with harnesses improperly routed may cause the harness to get caught and short out.• If the flat mat hook of the frame assembly - ...

Dtc p0107 manifold absolute pressure/barometric pressure sensor circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0107 MANIFOLD ABSOLUTE PRESSURE/BAROMETRIC PRESSURE SENSOR CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clea ...

Assembly
BRAKE > Master CylinderASSEMBLYCAUTION:When replacing the reservoir tank, adhere the label to the position shown in the figure. (C5 model)Preparation items:C5 modelPart No.: Label (25080GA010)(a)Label(b)Brake booster 1. Install the seal to the cylinder body assembly.2. Install the reservoir tank ...

© 2016-2026 Copyright www.sucross.com