Subaru Crosstrek Service Manual: Specification
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General Description
SPECIFICATION
1. MANUAL TRANSMISSION AND DIFFERENTIAL
Model | Crosstrek model | ||
Type | 5-forward speeds and 1-reverse (all stage with synchromesh) | ||
Transmission gear ratio | 1st | 3.545 | |
2nd | 1.888 | ||
3rd | 1.296 | ||
4th | 0.972 | ||
5th | 0.780 | ||
Rev. | 3.333 | ||
Front reduction gear | Final | Type of gear | Hypoid |
Gear ratio | 4.444 | ||
Rear reduction gear | Transfer | Type of gear | Helical |
Gear ratio | 1.000 | ||
Front differential | Type and number of gear | Straight bevel gear (bevel pinion: 2, bevel gear: 2) | |
Center differential | Type and number of gear | Straight bevel gear (bevel pinion: 2, bevel gear: 2 and viscous coupling) | |
Transmission gear oil | SUBARU GEAR OIL EXTRA MT or equivalent | ||
Transmission gear oil capacity | 3.5 L (3.7 US qt, 3.1 Imp qt) | ||
2. TRANSMISSION GEAR OIL
CAUTION:
If an alternative gear oil is used, you may not have expected functionality and performance.
Recommended oil:
SUBARU GEAR OIL EXTRA MT
Alternative:
GL-5 (75W-90)
Caution
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General DescriptionCAUTION• Remove contamination including dirt and corrosion before removal, installation or disassembly.• Keep the disassem ...
Component
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > General DescriptionCOMPONENT1. TRANSMISSION CASE(1)Transmission case ASSY(7)Pitching stopper bracketTightening torque: N·m (kgf-m, ft-lb)(2)Gasket ...
Other materials:
Assembly
STARTING/CHARGING SYSTEMS(H4DO) > StarterASSEMBLY1. Apply grease to the shaft sliding surfaces of the internal gear assembly.Grease:Multemp #6129 or equivalent2. Assemble the shaft to the internal gear assembly.3. Assemble the overrunning clutch as follows:(1) Apply grease to the spline portion o ...
Contrast setting
1. Perform the preparation steps according
to "Preparation for image quality and
volume settings"
2. Operate the "
" or ""
switch to
select the "Contrast" item. Then push the
button.
3. Select a contrast level by operating the
"
"
or "
" switch, and confirm the setting
b ...
Installation
SECURITY AND LOCKS > Remote OpenersINSTALLATION1. Before installation, check the following items.• Cable is free from deformation such as fray.2. Install each part in the reverse order of removal.Tightening torque:Front hood lock: General Description > COMPONENT">Remote opener: ...
