Subaru Crosstrek Service Manual: Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center Differential
INSPECTION
1. Ball bearing
Replace the bearings in the following cases.
• In case of broken or rusty bearings
• In case of worn or damaged bearings
• When the bearings fail to turn smoothly or emit noise in rotation after transmission gear oil has been applied.
• When bearing has other defects.
2. Center differential
If there is wear or damage, replace the center differential assembly.
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialDISASSEMBLYRemove the ball bearing using ST.NOTE:Center differential is a non-disassembled part which should not be disassembled.ST ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialINSTALLATION1. Attach the center differential to transfer case.2. Install the transfer driven gear. Transfer Driven Gear > INSTALL ...
Other materials:
Installation
INSTRUMENTATION/DRIVER INFO > Combination MeterINSTALLATIONCAUTION:• Make sure the electrical connector is connected securely.• Make sure that each meter operates normally.• When the combination meter assembly has been replaced, be sure to perform the following operations.– F ...
Dtc b2275 engine start request control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2275 ENGINE START REQUEST CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in engine start permission signal output circuit in the keyless access CM. ...
Disassembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyDISASSEMBLY1. Remove the drain separator from the leak check valve assembly. Drain Separator > REMOVAL">2. Disconnect the drain tube from the leak check valve assembly.NOTE:Disconnect the quick connector ...
