Subaru Crosstrek Service Manual: Installation

CAUTION:

• Make sure that packings are attached on the clips of the roof spoiler assembly. If a gasket is not attached, water leakage may occur.

• Make sure the bolt is tightened securely because improper installation may cause the water leakage.

1. Install the roof spoiler assembly.

Tightening torque:

7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

2. Connect the connector of high-mounted stop light.

3. Install the trim panel - rear gate UPR. Rear Gate Trim > INSTALLATION">

4. Connect the ground terminal to battery sensor. NOTE">

Roof spoiler

Removal

Other materials:

Dtc p0974 shift solenoid "a" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0974 SHIFT SOLENOID "A" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not changed. (No up-shift)CAUTION:Use the check boar ...

Daytime running light system
WARNING The brightness of the illumination of the high beam headlights is reduced by the daytime running light system. The light switch must always be turned to the " " position when it is dark outside. The high beam headlights will automatically illuminate at reduced brightness when the ...

Dtc c0023 front left abs sensor circuit open or short
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0023 FRONT LEFT ABS SENSOR CIRCUIT OPEN OR SHORTNOTE:For the diagnostic procedure, refer to “DTC C0027 REAR LEFT ABS SENSOR CIRCUIT OPEN OR SHORT”. Diagnostic Procedure with Dia ...