Subaru Crosstrek Service Manual: Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler Gear
INSPECTION
1. Move the reverse shifter rod toward the reverse side. Check the clearance between the reverse idler gear and the transmission case wall surface.
If the value is out of specification, select the appropriate reverse shifter lever and adjust. Reverse Idler Gear > ADJUSTMENT">
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
2. After installing a suitable reverse shifter lever, shift into neutral. Check the clearance between the reverse idler gear and the transmission case wall surfaces.
If the value is out of specification, select the appropriate adjusting washer and adjust. Reverse Idler Gear > ADJUSTMENT">
Clearance:
0 — 0.5 mm (0 — 0.020 in)
3. Check the reverse idler gear and shaft for damage. Replace if it is damaged.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the b ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearINSTALLATION1. Install the reverse shifter lever, adjusting washer, reverse idler gear, reverse idler gear shaft and washer, and secure ...
Other materials:
Location
EyeSight > Relay and FuseLOCATIONRelay & fuse boxFuse 10 A (stop light and brake switch, brake light relay)(A)Relay holderBrake light relay(B)NOTE:For other related fuses, refer to the wiring diagram. Power Supply Circuit"> ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidINSPECTION1. Check that the oil control solenoid has no deformation, cracks or other damages.2. Measure the resistance between the oil control solenoid terminals.Terminal No.Standard1 and 27.25±0.4 ? (when 20°C (68°F ...
Voice command example: Call
name
1. Press the talk switch on the steering
wheel.
2. Say "Call <contacts>"
A confirmation screen will be displayed
showing the recognition results.
If multiple matching items are
found, a selection screen will be
displayed. Say "<number>" or select
the number.
NOTE
...
