Subaru Crosstrek Service Manual: Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential Assembly
INSTALLATION
1. Install the differential side retainers using ST.
| ST 18630AA010 | WRENCH COMPL RETAINER |
2. Install the taper roller bearing outer race to the transmission case.
3. Install the front differential assembly.
NOTE:
Be careful not to bend the seal lips of oil seal.
4. Install the main shaft assembly. Main Shaft Assembly > INSTALLATION">
5. Install the drive pinion shaft assembly. Drive Pinion Shaft Assembly > INSTALLATION">
6. Install the transmission case. Transmission Case > INSTALLATION">
7. Install the transfer case together with the extension case assembly. Transfer Case and Extension Case Assembly > INSTALLATION">
8. Install the manual transmission assembly to the vehicle. Manual Transmission Assembly > INSTALLATION">
Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyINSPECTIONRepair or replace the differential gear in the following cases:• When the hypoid driven gear and drive pinion ...
Other materials:
Removal
SECURITY AND LOCKS > Security Control ModuleREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Do not allow harness and connecto ...
Initial screen
When the ignition switch is in the "ACC" or
"ON" position, the initial screen will be
displayed and the system will begin
operating.
When using the SUBARU STARLINK
function (if equipped), the display screen
may be different from the screen above.
After a few seconds, the caution scr ...
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Control PanelREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from b ...
