Subaru Crosstrek Service Manual: Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting System
INSPECTION
Check the following; repair or replace the faulty parts.
1. PITCHING STOPPER
Check the pitching stopper for bends or damage. Check that the rubber is not stiff, cracked or otherwise damaged.
2. CROSSMEMBER AND CUSHION RUBBER
Check the crossmember for bending or damage. Check that the cushion rubber does not have hardening, cracks or other damages.
Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Mounting SystemREMOVAL1. PITCHING STOPPER1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loos ...
Other materials:
Dtc b1572 imm circuit except antenna circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1572 IMM CIRCUIT EXCEPT ANTENNA CIRCUIT1. EXCEPT FOR C0 AND C5 MODELSDTC detecting condition:Communication error between keyless access CM and ECMTrouble symptom:Engine will no ...
Dtc c0057 ecm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0057 ECM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from ECM.Trouble symptom:• VDC does not operate.• EyeSight does not operate.STEPCHECKYESNO1.CHECK LAN SYSTEM.P ...
Assembly
DRIVE SHAFT SYSTEM > Front Hub Unit BearingASSEMBLY1. Install the hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)2. Using a press, press the new hub bolts (b) until their seating surfaces contact the hub unit bearing (a).NOTE:Use the 12 mm (0.47 in) dia. holes in th ...
